diff options
Diffstat (limited to 'docs/devel/migration/postcopy.rst')
| -rw-r--r-- | docs/devel/migration/postcopy.rst | 31 |
1 files changed, 16 insertions, 15 deletions
diff --git a/docs/devel/migration/postcopy.rst b/docs/devel/migration/postcopy.rst index 6c51e96d79..82e7a848c6 100644 --- a/docs/devel/migration/postcopy.rst +++ b/docs/devel/migration/postcopy.rst @@ -99,17 +99,6 @@ ADVISE->DISCARD->LISTEN->RUNNING->END (although it can't do the cleanup it would do as it finishes a normal migration). - - Paused - - Postcopy can run into a paused state (normally on both sides when - happens), where all threads will be temporarily halted mostly due to - network errors. When reaching paused state, migration will make sure - the qemu binary on both sides maintain the data without corrupting - the VM. To continue the migration, the admin needs to fix the - migration channel using the QMP command 'migrate-recover' on the - destination node, then resume the migration using QMP command 'migrate' - again on source node, with resume=true flag set. - - End The listen thread can now quit, and perform the cleanup of migration @@ -221,7 +210,8 @@ paused postcopy migration. The recovery phase normally contains a few steps: - - When network issue occurs, both QEMU will go into PAUSED state + - When network issue occurs, both QEMU will go into **POSTCOPY_PAUSED** + migration state. - When the network is recovered (or a new network is provided), the admin can setup the new channel for migration using QMP command @@ -229,9 +219,20 @@ The recovery phase normally contains a few steps: - On source host, the admin can continue the interrupted postcopy migration using QMP command 'migrate' with resume=true flag set. - - - After the connection is re-established, QEMU will continue the postcopy - migration on both sides. + Source QEMU will go into **POSTCOPY_RECOVER_SETUP** state trying to + re-establish the channels. + + - When both sides of QEMU successfully reconnect using a new or fixed up + channel, they will go into **POSTCOPY_RECOVER** state, some handshake + procedure will be needed to properly synchronize the VM states between + the two QEMUs to continue the postcopy migration. For example, there + can be pages sent right during the window when the network is + interrupted, then the handshake will guarantee pages lost in-flight + will be resent again. + + - After a proper handshake synchronization, QEMU will continue the + postcopy migration on both sides and go back to **POSTCOPY_ACTIVE** + state. Postcopy migration will continue. During a paused postcopy migration, the VM can logically still continue running, and it will not be impacted from any page access to pages that |