hw/arm/mps2-tz: Put ethernet controller behind PPC

The ethernet controller in the AN505 MPC FPGA image is behind
the same AHB Peripheral Protection Controller that handles
the graphics and GPIOs. (In the documentation this is clear
in the block diagram but the ethernet controller was omitted
from the table listing devices connected to the PPC.)
The ethernet sits behind AHB PPCEXP0 interface 5. We had
incorrectly claimed that this was a "gpio4", but there are
only 4 GPIOs in this image.

Correct the QEMU model to match the hardware.

Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Message-id: 20180515171446.10834-1-peter.maydell@linaro.org

0 files changed, 0 insertions, 0 deletions