libvhost-user: Dynamically remap rings after (temporarily?) removing memory regions

Currently, we try to remap all rings whenever we add a single new memory
region. That doesn't quite make sense, because we already map rings when
setting the ring address, and panic if that goes wrong. Likely, that
handling was simply copied from set_mem_table code, where we actually
have to remap all rings.

Remapping all rings might require us to walk quite a lot of memory
regions to perform the address translations. Ideally, we'd simply remove
that remapping.

However, let's be a bit careful. There might be some weird corner cases
where we might temporarily remove a single memory region (e.g., resize
it), that would have worked for now. Further, a ring might be located on
hotplugged memory, and as the VM reboots, we might unplug that memory, to
hotplug memory before resetting the ring addresses.

So let's unmap affected rings as we remove a memory region, and try
dynamically mapping the ring again when required.

Acked-by: Raphael Norwitz <raphael@enfabrica.net>
Acked-by: Stefano Garzarella <sgarzare@redhat.com>
Signed-off-by: David Hildenbrand <david@redhat.com>
Message-Id: <20240214151701.29906-14-david@redhat.com>
Tested-by: Mario Casquero <mcasquer@redhat.com>
Reviewed-by: Michael S. Tsirkin <mst@redhat.com>
Signed-off-by: Michael S. Tsirkin <mst@redhat.com>

0 files changed, 0 insertions, 0 deletions