usb: move USB_REQ_{GET,SET}_CONFIGURATION handling to common code

This patch adds fields to the USBDevice struct for the current
speed (hard-wired to full speed for now) and current device
configuration.  Also a init function is added which inializes
these fields.  This allows USB_REQ_{GET,SET}_CONFIGURATION
handling to be moved to common code.

For most drivers the conversion is trivial ad they support a single
configuration only anyway.  One exception is bluetooth where some
device-specific setup code runs after get/set configuration.  The
other is usb-net which actually has two configurations so the
the code to check for the active configuration has been adapted.

Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>

1 files changed, 1 insertions, 8 deletions

diff --git a/hw/usb-msd.c b/hw/usb-msd.c
index b54ccbc599..56c6f3dcf2 100644
--- a/hw/usb-msd.c
+++ b/hw/usb-msd.c
@@ -261,13 +261,6 @@ static int usb_msd_handle_control(USBDevice *dev, int request, int value,
         }
         ret = 0;
         break;
-    case DeviceRequest | USB_REQ_GET_CONFIGURATION:
-        data[0] = 1;
-        ret = 1;
-        break;
-    case DeviceOutRequest | USB_REQ_SET_CONFIGURATION:
-        ret = 0;
-        break;
     case DeviceRequest | USB_REQ_GET_INTERFACE:
         data[0] = 0;
         ret = 1;
@@ -502,7 +495,7 @@ static int usb_msd_initfn(USBDevice *dev)
         usb_desc_set_string(dev, STR_SERIALNUMBER, dinfo->serial);
     }
 
-    s->dev.speed = USB_SPEED_FULL;
+    usb_desc_init(dev);
     scsi_bus_new(&s->bus, &s->dev.qdev, 0, 1, usb_msd_command_complete);
     s->scsi_dev = scsi_bus_legacy_add_drive(&s->bus, bs, 0);
     if (!s->scsi_dev) {