hw/riscv: virt: Enable booting S-mode firmware from pflash

To boot S-mode firmware payload like EDK2 from persistent
flash storage, qemu needs to pass the flash address as the
next_addr in fw_dynamic_info to the opensbi.

When both -kernel and -pflash options are provided in command line,
the kernel (and initrd if -initrd) will be copied to fw_cfg table.
The S-mode FW will load the kernel/initrd from fw_cfg table.

If only pflash is given but not -kernel, then it is the job of
of the S-mode firmware to locate and load the kernel.

In either case, update the kernel_entry with the flash address
so that the opensbi can jump to the entry point of the S-mode
firmware.

Signed-off-by: Sunil V L <sunilvl@ventanamicro.com>
Reviewed-by: Andrew Jones <ajones@ventanamicro.com>
Reviewed-by: Alistair Francis <alistair.francis@wdc.com>
Message-Id: <20221004092351.18209-4-sunilvl@ventanamicro.com>
Signed-off-by: Alistair Francis <alistair.francis@wdc.com>

1 files changed, 1 insertions, 0 deletions

diff --git a/include/hw/riscv/boot.h b/include/hw/riscv/boot.h
index a36f7618f5..93e5f8760d 100644
--- a/include/hw/riscv/boot.h
+++ b/include/hw/riscv/boot.h
@@ -57,5 +57,6 @@ void riscv_rom_copy_firmware_info(MachineState *machine, hwaddr rom_base,
                                   uint32_t reset_vec_size,
                                   uint64_t kernel_entry);
 void riscv_setup_direct_kernel(hwaddr kernel_addr, hwaddr fdt_addr);
+void riscv_setup_firmware_boot(MachineState *machine);
 
 #endif /* RISCV_BOOT_H */